CitroenBerlingo 1.6 HDI 90 16V Stage 1 Remap ( 120 BHP | 270 Nm) Our stage 1 remap for the Citroen Berlingo 1.6 HDI 90 16V engine delivers steady and enhanced torque throughout the entire rev spectrum, ensuring it’s well within the safety boundaries of your clutch and turbo charger. The torque output is even and doesn’t run out at higher
TheStarter motor. The car was running fine (after I replaced the alternator) and then today it blew the starter motor fuse (no. 8). I put another fuse in which
Joined Thu Jan 10, 2008 7:53 pm. x 5. Re: 1.6 HDi Turbo change. by uncle buck » Thu Jan 23, 2014 8:38 pm. You want to alter the sump drain bolt recess while you have the sump off. IN THIS THREAD (2nd post from the bottom) Axa pushed the sump bolt recess down so it sticks downwards out of the sump instead of upwards into the sump.
Onthe gearbox, remove the release bearing and then inspect each of the sleeve/guide tube, release fork and ball pivot for wear and replace if required. Remove any clutch dust by cleaning the bell housing and fit the new release bearing. Lightly lubricate the clutch splines on the input shaft with high melting point grease and evenly distribute
However such a nuisance as wear of the camshaft cams on a 1.6 HDi engine can be encountered today, but for a different reason: due to the development of an oil pump on the gears. In this case, the performance of the oil system decreases, first of all, the camshafts and the turbine suffer. The alarm lamp will light up only when the oil pressure
. 355 230 92 96 314 63 279 163
1.6 hdi starter motor removal
